If you look closer, you can also see that the stepper drivers are not the regular Trinamic drivers. Inside the electronics area, we get a CR-FDM-v2.4.S1.200 32-bit board with an ARM STM32F401 CPU made by Creality which is similar to the one installed on the Ender 3 S1. Besides that, the air duct is not designed with airflow in mind, and this causes the part cooling on the Sermoon V1 Pro to be unsatisfactory if the print speed is higher. It’s easy for it to take in small wisps of plastic during printing. The part cooling fan is orientated to pull air from the bottom which is less than ideal. I can also see a connector available for a CR-Touch leveling sensor, which is probably something we will see in another Creality printer in the future. All the wiring is handled by the small breakout board which is connected to the mainboard using a ribbon cable. The extruder is really easy to remove from the printer, allowing easy troubleshooting or replacement, if needed. The all-metal heat break is reserved for the Sprite Pro extruder which is able to print materials up to 300C. The hotend is still PTFE lined, so you are limited with printing up to ~240C. It’s compact, with dual gears for good filament feeding, and performs very well with most of the filaments you can throw at it. I really hope this trend moves to cheaper Creality 3D printers because the Sprite extruder is one of the best you can get right now. I think you can see a pattern here, where this extruder is installed on the pro machines. This is the same extruder present on other printers from Creality, like the Ender 3 S1 / S1 Pro or the CR-10 Smart Pro. One of the best features of the Creality Sermoon V1 Pro is the Creality Sprite Extruder. The transparent top cover of the machine can be removed, if you ever need to access the extruder assembly or perform maintenance which is helpful. Compared to Creality’s other 3D printers, the V1 Pro has one of the smallest printing volumes. Creality Sermoon V1 Pro Specs Print TechnologyĪs previously mentioned, the Creality Sermoon V1 Pro is a fully enclosed 3D printer with a print volume of 175x175x165.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |